Carlson Engineering has the deepest product offering of fixtured screwdriving heads on the market today These drive heads are mounted to cartesian robots, transfer lines, fixtures, SCARA robots, work cells, and indexing stations.
We build drive heads to drive screws one at a time or many screws at once. All of our drive heads use high load liner guide bearings and are designed to operate 3 shifts a day with minimal maintenance.
4 models - 4, 6, 8, and 10 inch stroke.
2 Models - 3 and 6 inch stroke
2 Models - 8 and 10 inch stroke
1 Model - 12 inch stroke
1 Model - 12 inch stroke.
These core products also have 4 sub product ranges within them.
Type 1- Designed to work with a screwfeeder. This is a two stage slide with travel to part and bit stroke.
Type 2 - Designed to work with a screw presenter for pick and place applications. This is a two stage slide the same as the Type 1. It has a vacuum pick up finder in place of the jaws that hold the screw.
Type 3 - Designed to be a self feed nut runner or thread checker.
Type 4 - Designed to work with a screwfeeder or screw presenter. This is a single stage slide which must be lowered into position above the work piece. It is normally used with a robot that has a Z-axis or mounted to another slide.
